|
|
Post by Spooty Biscuit on Jun 24, 2006 22:28:11 GMT -5
One of my Ignition 3.0's had an issue today with the sensor on the left pad sliding halfway into the middle of the pad (not too long after the warranty expires, figures). I was able to push it back, but I'm thinking that it's only a temporary fix. Anyone have a good way to fix this (aside from getting a new pad)?
|
|
|
|
Post by abrannan on Jun 25, 2006 8:18:09 GMT -5
It's actually not the sensor itself, but the raised panel (I've had it happen to other pads). The problem is that they layers that contain the raised panels are covered with some form of adhesive, and opening the pad up to re-set the panel is a messy nightmare.
|
|
|
|
Post by Spooty Biscuit on Jun 25, 2006 21:30:22 GMT -5
Meh, well regardless, the pad sucks. I've had it for 4 months, it's enjoyed very light use as it's always plugged into the 2P side, but the left sensor does this, seems to sometimes respond when I lift my foot off the pad, and everyone else in my family has had issues with the right pad (aside from me, don't know what they're issues are).
My other Ignition, on the other hand, is 6 months old, has been used much more often and taken way more abuse, yet has never had an issue aside from the cover ripping in the corner during transport to a friend's house.
Meh, just goes to show you the inconsistancy of soft mats. I really gotta look into investing on hard mats...
|
|
